A look into a crystal ball reveals the secrets of perovskite solar cell stability

Scientists in Switzerland and South Korea looked deep into the crystalline structure of a perovskite thin-film to better understand the mechanisms behind the sensitivity to heat and moisture that causes so many stability issues for solar cells based on these materials. They discovered a part of the crystal’s surface that is particularly vulnerable to moisture-induced degradation, and developed an approach to grow perovskite thin-films with strong resistance to moisture and thermal stress.

While the high conversion efficiencies achieved with perovskite solar cell materials have garnered plenty of attention in recent years, the accompanying sensitivity to heat and moisture still present a challenge to commercialization.

Plenty of additives, encapsulants and barrier layers have been suggested to fix this, but understanding the exact mechanisms that take place within the material to cause damage upon contact with heat and water could open up pathways to a more comprehensive solution. This was the goal of scientists led by École polytechnique fédérale de Lausanne (EPFL) in Switzerland and South Korea’s Sungkyunkwan University, who looked deep into the crystalline structure of a perovskite to work out what was going on.

The group analyzed different facets – flat faces on the surface of the crystal. Their results are published in the paper Unveiling facet-dependent degradation and facet engineering for stable perovskite solar cells, published in Science. The group found one common facet, the 100 facet, which it describes as “perpendicular to a crystal’s c-axis with its atoms arranged in a repeating pattern in the form of a square grid”, was particularly unstable when exposed to moisture.

Another facet, named 111 and described as “atoms arranged in a triangular grid,” was shown to be much more moisture resistant. And the group set about engineering a new perovskite film that would grow with more of the 111 facet and less of the 100. The group used the films to make solar cells that achieved 23.8% efficiency, and these maintained 85% of their initial performance after 800 hours under test conditions of 85% humidity and a temperature of 85 C, while a control sample fell to 75% of its initial performance value under the same conditions.

The group says various optimizations should be able to improve the PV performance of the newly engineered perovskite, and that it expects this type of facet engineering to be a valuable tool in developing perovskite solar cells that can meet market expectations for performance and longevity.

This post appeared first on PV Magazine.

Share This Post